F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

432
Ste
p
Command Remarks
330. Enter system view. system-view N/A
331. Enter interface view.
interface interface-type interface-number N/A
332. Configure the network
type for the interface
as P2P.
isis circuit-type p2p
Optional.
By default, the network type of an
interface depends on the physical
media.
175B
Configuring IS-IS routing information control
Perform the tasks in this section to affect IS-IS route selection.
673BConfiguration prerequisites
Before the configuration, complete the following tasks:
• Configure IP addresses for all interfaces to ensure IP connectivity between neighboring nodes.
• Enable IS-IS.
674BConfiguring IS-IS link cost
The IS-IS cost of an interface is determined in the following order:
1. IS-IS cost specified in interface view.
2. IS-IS cost specified in system view. The cost is applied to the interfaces associated with the IS-IS
process.
3. Automatically calculated cost. If the cost style is wide or wide-compatible, IS-IS automatically
calculates the cost using the formula: interface cost=(bandwidth reference value/interface
bandwidth) ×10, in the range of 1 to 16777214. For other cost styles,
2642HTable 54 applies.
Table 54 Automatic cost calculation scheme for cost styles other than wide and wide-compatible
Interface bandwidth Interface cost
≤ 10 Mbps 60
≤ 100 Mbps 50
≤ 155 Mbps 40
≤ 622 Mbps 30
≤ 2500 Mbps 20
> 2500 Mbps 10
4. If none of the above costs is used, a default cost of 10 applies.
1458BConfiguring an IS-IS cost for an interface
Ste
p
Command Remarks
333. Enter system view.
system-view N/A