F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

465
To enable a router to run BGP, you must specify a router ID, the unique identifier of the router in the AS.
By default, if no global router ID is configured, the highest loopback interface IP address, if any, is used
as the router ID. If no loopback interface IP address is available, the highest physical interface IP address
is used, regardless of the interface status. Use loopback interface IP address as a router ID to increase the
network availability.
704BConfiguring BGP globally
1. Select Network > Routing Management > BGP from the navigation tree.
The BGP global configuration page appears.
Figure 283 BGP global configuration page
2. Configure BGP globally as described in 2651HTable 55.
3. Click Apply.
Table 55 Configuration items
Item Descri
p
tion
Enable BGP Enable BGP.
AS Specify a local AS number.
Import static routes Configure BGP to redistribute active static routes (except default routes).
705BConfiguring BGP peer
1. Select Network > Routing Management > BGP from the navigation tree.
The BGP configuration page appears.