F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

470
b. Select the Enable BGP box, and enter 65009 for AS.
c. Click Apply.
3. Configure IBGP connections:
a. Click Add in the Peer Configuration field.
b. Enter 9.1.1.1 for Peer IP Address and 65009 for Peer AS.
c. Click Apply.
d. Click Add in the Peer Configuration field.
e. Enter 9.1.2.1 for Peer IP Address and 65009 for Peer AS.
f. Click Apply.
1483BVerifying the configuration
1. Select Network > Routing Management > BGP from the navigation tree of Device B.
2. Click Show Peer in the Show Information field.
BGP connections are established from Device B to other devices.
Figure 291 BGP configuration result
185B
Configuring BGP at the CLI
708BBGP configuration task list
In a basic BGP network, you only need to perform the following configurations:
• Enable BGP.
• Configure BGP peers or peer groups.
• Control BGP route generation.
To control BGP route distribution and path selection, you must perform other configurations.
If you configure a BGP setting for a peer group and a peer in the group, the last configuration takes
effect.
Complete the following tasks to configure BGP:
Task Remarks
2653H
Configuring basic
BGP
2654H
Enabling BGP Required.
2655H
Configuring a BGP peer Required.
HP recommends
configuring BGP peer
groups on large scale BGP
networks for easy
configuration and
maintenance.
2656H
Configuring a BGP peer group