F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

494
Local
p
arameter
Peer
p
arameter
Ne
g
otiation result
receive
send
both
The local end can only receive ORF information, and the
peer end can only send ORF information.
both both
Both the local and peer ends can send and receive ORF
information.
1507BEnabling 4-byte AS number suppression
When a device that supports 4-byte AS numbers sends an Open message for session establishment, the
Optional parameters field of the message indicates that the AS number occupies four bytes—in the
range of 1 to 4294967295. If the peer device does not support 4-byte AS numbers (for examples, it
supports only 2-byte AS numbers), the session cannot be established.
After you enable the 4-byte AS number suppression function, the peer device can then process the Open
message even though it does not support 4-byte AS numbers, and the BGP session can be established.
If the peer device supports 4-byte AS numbers, do not enable the 4-byte AS number suppression function;
otherwise, the BGP peer relationship cannot be established.
To enable 4-byte AS number suppression:
Ste
p
Command
Remarks
584. Enter system view.
system-view N/A
585. Enter BGP view or BGP-VPN
instance view.
Enter BGP view:
bgp as-number
Enter BGP-VPN instance view:
a. bgp as-number
b. ipv4-family vpn-instance
vpn-instance-name
Use either approach.
586. Enable 4-byte AS number
suppression.
peer { group-name | ip-address }
capability-advertise suppress-4-byte-as
Disabled by default.
1508BEnabling quick reestablishment of direct EBGP session
When the link to a directly connected EBGP peer is down, the router, with quick EBGP session
reestablishment enabled, tears down the session to the peer, and then reestablishes a session
immediately. If the function is not enabled, the router does not tear down the session until the holdtime
times out. A route flap does not affect the EBGP session state when the quick EBGP session
reestablishment is disabled.
To enable quick reestablishment of direct EBGP session:
Ste
p
Command
Remarks
587. Enter system view.
system-view N/A
588. Enter BGP view or BGP-VPN
instance view.
Enter BGP view:
bgp as-number
Enter BGP-VPN instance view:
a. bgp as-number
b. ipv4-family vpn-instance
vpn-instance-name
Use either approach.