F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

512
4. Verify the configuration:
# Display the BGP routing table on Firewall.
[Firewall] display bgp routing-table
Total Number of Routes: 3
BGP Local router ID is 1.1.1.1
Status codes: * - valid, ^ - VPNv4 best, > - best, d - damped,
h - history, i - internal, s - suppressed, S - Stale
Origin : i - IGP, e - EGP, ? - incomplete
Network NextHop MED LocPrf PrefVal Path/Ogn
*> 8.1.1.0/24 0.0.0.0 0 0 i
*> 9.1.1.0/24 3.1.1.1 0 0 65009i
*> 3.1.2.1 0 0 65009i
{ The output shows two valid routes to the destination 9.1.1.0/24, and both of them are marked
with a greater-than sign (>), indicating they are the best routes.
{ By using the display ip routing-table command, you can find two routes to 9.1.1.0/24: one with
next hop 3.1.1.1 and output interface GigabitEthernet 0/1, the other with next hop 3.1.2.1 and
output interface GigabitEthernet 0/2.
722BBGP route summarization configuration example
1529BNetwork requirements
As shown in 2703HFigure 299, run EBGP between Firewall and Router C, so the internal network and external
network can communicate with each other.
In AS 65106, configure static routing between Router A and Router B, configure OSPF between Router B
and Firewall, and configure OSPF to redistribute static routes, so devices in the internal network can
communicate with each other.
Configure route summarization on Firewall so BGP advertises a summary route instead of the specific
networks 192.168.64.0/24, 192.168.74.0/24, and 192.168.99.0/24 to Router D.
Figure 299 Network diagram