F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

538
Item Descri
p
tion
Default Next Hop Enter the default next hop IP address.
Outbound Interface
Enter the outbound interface. (This option is available after you click Show Advanced.)
Non-P2P interfaces (broadcast and NBMA interfaces, such as Ethernet and
virtual-template interfaces) may have multiple next hops, and packets may not be
forwarded successfully.
Default Outbound
Interface
Enter the default outbound interface. (This option is available after you click Show
Advanced.)
Non-P2P interfaces (broadcast and NBMA interfaces, such as Ethernet and
virtual-template interfaces) may have multiple next hops, and packets may not be
forwarded successfully.
Table 62 IP preference values and keywords
Preference value
Ke
y
word
0 routine
1 priority
2 immediate
3 flash
4 flash-override
5 critical
6 internet
7 network
1548BConfiguring a policy node
To configure a node for an existing policy, use one of the following methods:
• Click Add in
2714HFigure 306 to enter the policy configuration page as shown in 2715HFigure 307. Enter the
name of the policy in the Policy Name field, and then configure its node.
• Click the policy name link in
2716HFigure 306 to enter the policy node list page, as shown in 2717HFigure 308.
You can create, modify, or remove a policy node on the page. To create a policy node, click Add
to enter the policy node configuration page (the policy name cannot be modified), as shown
in
2718HFigure 309. For descriptions of the configuration items, see "2719HCreating a policy and a policy
node."