F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

598
Figure 343 Network diagram
Device Interface IP address Device Interface IP address
Device A GE0/1 192.168.2.1/24 Device C GE0/1 10.1.1.1/24
GE0
/
3 10.1.1.2
/
24 GE0
/
2 10.1.2.1/24
Device B GE0
/
1 192.168.3.1/24 GE0
/
3 192.168.1.1/24
GE0/3 10.1.2.2/24
This example assumes that the IP address has been configured for each interface according to the
network diagram, the security zone is configured, and OSPF has been enabled on the devices in the
PIM-DM domain to ensure the network-layer interoperation in the PIM-DM domain and enable dynamic
update of routing information through a unicast routing protocol.
1610BConfiguring Device A
1. Enable IP multicast routing:
a. From the navigation tree, select Network > Routing Management > Multicast Routing.
b. Select Enable from the list.
c. Click Apply.
Figure 344 Enabling IP multicast routing
2. Enable IGMP on GigabitEthernet 0/1 that connects to the stub network:
a. From the navigation tree, select Network > Routing Management > IGMP.
b. Click the icon for GigabitEthernet 0/1.
c. Select Enable from the list to enable IGMP.
d. Specify the IGMP version as 2.
Ethernet
Ethernet
Source
192.168.1.16/24
PIM-DM
Device A
Device B
Device C
Receiver
Host A
Host B
N1
GE0/1
192.168.2.1/24
GE0/1
192.168.3.1/24
GE0/3
192.168.1.1/24
GE0/2
10.1.2.1/24
GE0/1
10.1.1.1/24
Ethernet
Receiver
Host C
Host D
N2
GE0/3
10.1.2.2/24
GE0/3
10.1.1.2/24