F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

599
e. Click Apply.
Figure 345 Enabling IGMP
3. Enable PIM-DM on each interface:
a. From the navigation tree, select Network > Routing Management > PIM.
b. Click the icon for GigabitEthernet 0/1.
c. Specify the operating mode as PIM-DM.
d. Click Apply.
e. Click the icon corresponding to GigabitEthernet 0/3.
f. Specify the operating mode as PIM-DM.
g. Click Apply.
Figure 346 Enabling PIM-DM
1611BConfiguring Device B
Configure Device B in the same way as you configure Device A. (Details not shown)
1612BConfiguring Device C
1. Enable IP multicast routing:
a. From the navigation tree, select Network > Routing Management > Multicast Routing.
b. Select Enable from the list.
c. Click Apply.
2. Enable PIM-DM on each interface:
a. From the navigation tree, select Network > Routing Management > PIM.
b. Click the icon for GigabitEthernet 0/3.
c. Specify the operating mode as PIM-DM.
d. Click Apply.
e. Click the icon for GigabitEthernet 0/1.
f. Specify the operating mode as PIM-DM.
g. Click Apply.
h. Click the icon corresponding to GigabitEthernet 0/2.