F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

600
i. Specify the operating mode as PIM-DM.
j. Click Apply.
1613BVerifying the configuration
To display PIM neighbor information on Device C:
1. From the navigation tree, select Network > Routing Management > PIM.
2. Click the Neighbor Information tab.
Figure 347 PIM neighbor information
202B
Configuring PIM at the CLI
203B
Configuring PIM-DM at the CLI
This section describes how to configure PIM-DM.
767BPIM-DM configuration task list
Task Remarks
2782H
Enabling PIM-DM Required.
2783H
Enabling state-refresh capability Optional.
2784H
Configuring state-refresh parameters Optional.
2785H
Configuring PIM-DM graft retry period Optional.
2786H
Configuring common PIM features at the CLI Optional.
768BConfiguration prerequisites
Before you configure PIM-DM, complete the following tasks:
• Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
• Determine the interval between state-refresh messages.
• Determine the minimum time to wait before receiving a new refresh message.
• Determine the TTL value of state-refresh messages.
• Determine the graft retry period.