F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

603
Task Remarks
2793H
Configuring C-RP timers globally Optional.
2794H
Configuring a BSR
2795H
Configuring a C-BSR Required.
2796H
Configuring a PIM domain border Optional.
2797H
Configuring global C-BSR parameters Optional.
2798H
Configuring C-BSR timers Optional.
2799H
Disabling BSM semantic fragmentation Optional.
2800H
Configuring administrative scoping
2801H
Enabling administrative scoping Optional.
2802H
Configuring an admin-scope zone boundary Optional.
2803H
Configuring C-BSRs for each admin-scope zone
and the global-scope zone
Optional.
2804H
Configuring multicast source registration Optional.
2805H
Configuring switchover to SPT Optional.
2806H
Configuring common PIM features at the CLI Optional.
774BConfiguration prerequisites
Before you configure PIM-SM, complete the following tasks:
• Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
• Determine the IP address of a static RP and the ACL rule defining the range of multicast groups to
be served by the static RP.
• Determine the C-RP priority and the ACL rule defining the range of multicast groups to be served by
each C-RP.
• Determine the legal C-RP address range and the ACL rule defining the range of multicast groups to
be served.
• Determine the C-RP-Adv interval.
• Determine the C-RP timeout timer.
• Determine the C-BSR priority.
• Determine the hash mask length.
• Determine the ACL rule defining a legal BSR address range.
• Determine the BS period.
• Determine the BS timeout timer.
• Determine the ACL rule for register message filtering.
• Determine the register suppression time.
• Determine the register probe time.
• Determine the multicast traffic rate threshold, ACL rule, and sequencing rule for a switchover to SPT.
• Determine the interval of checking the traffic rate threshold before a switchover to SPT.