F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

614
2. Configuration procedure
To configure an SSM multicast group range:
Ste
p
Command Remarks
830. Enter system view.
system-view N/A
831. Enter public network PIM view. pim N/A
832. Configure the SSM group range.
ssm-policy acl-number
Optional.
232.0.0.0/8 by default.
206B
Configuring common PIM features at the CLI
For the configuration tasks in this section, the following rules apply:
• The configurations made in PIM view are effective on all interfaces. The configurations made in
interface view are effective only on the current interface.
• A configuration made in interface view always has priority over the same configuration made in
PIM, regardless of the configuration sequence.
785BConfiguration task list
Task Remarks
2814H
Configuring a multicast data filter Optional.
2815H
Configuring a hello message filter Optional.
2816H
Configuring PIM hello options Optional.
2817H
Setting the prune delay timer Optional.
2818H
Configuring common PIM timers Optional.
2819H
Configuring join/prune message sizes Optional.
786BConfiguration prerequisites
Before you configure common PIM features, complete the following tasks:
• Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
• Configure PIM-DM, or PIM-SM, or PIM-SSM.
• Determine the ACL rule for filtering multicast data.
• Determine the ACL rule defining a legal source address range for hello messages.
• Determine the priority for DR election (global value/interface level value).
• Determine the PIM neighbor timeout timer (global value/interface value).
• Determine the prune message delay (global value/interface level value).
• Determine the prune override interval (global value/interface level value).
• Determine the prune delay.
• Determine the hello interval (global value/interface level value).