F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

619
Ste
p
Command Remarks
864. Enter system view. system-view N/A
865. Enter interface view.
interface interface-type
interface-number
N/A
866. Configure the hello interval.
pim timer hello interval
Optional.
30 seconds by default.
867. Configure the maximum delay
between hello messages.
pim triggered-hello-delay interval
Optional.
5 seconds by default.
868. Configure the join/prune
interval.
pim timer join-prune interval
Optional.
60 seconds by default.
869. Configure the join/prune
timeout timer.
pim holdtime join-prune interval
Optional.
210 seconds by default.
870. Configure assert timeout
timer.
pim holdtime assert interval
Optional.
180 seconds by default.
792BConfiguring join/prune message sizes
A large join/prune message size might result in loss of a larger amount of information if a message is lost.
You can set a small value for the size of each join/prune message to reduce the impact in case of the loss
of a message.
By controlling the maximum number of (S, G) entries in each join/prune message, you can effectively
reduce the number of (S, G) entries sent per unit of time.
To configure join/prune message sizes:
Ste
p
Command Remarks
871. Enter system view.
system-view
N/A
872. Enter public network PIM
view.
pim N/A
873. Configure the maximum size
of each join/prune message.
jp-pkt-size packet-size
Optional.
8100 bytes by default.
874. Configure the maximum
number of (S, G) entries in
each join/prune message.
jp-queue-size queue-size
Optional.
1020 by default.
793BDisplaying and maintaining PIM
Task Command Remarks
Display information about the
BSR in the PIM-SM domain and
the locally configured C-RP.
display pim bsr-info [ | { begin | exclude | include }
regular-expression ]
Available in
any view.
Display information about the
unicast routes used by PIM.
display pim claimed-route [ source-address ] [ | { begin |
exclude | include } regular-expression ]
Available in
any view.