F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

630
2. Configuration procedure
a. Assign an IP address and subnet mask to each interface according to 2825HFigure 350. (Details not
shown.)
b. Configure OSPF on the routers in the PIM-SM domain to make sure they are interoperable at
the network layer. (Details not shown.)
c. Enable IP multicast routing and administrative scoping, enable IGMP and PIM-SM:
# On Router A, enable IP multicast routing and administrative scoping, enable IGMP on the
host-side interface Ethernet 1/1, and enable PIM-SM on each interface.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] pim
[RouterA-pim] c-bsr admin-scope
[RouterA-pim] quit
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] igmp enable
[RouterA-Ethernet1/1] pim sm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] pim sm
[RouterA-Ethernet1/2] quit
# Enable IP multicast routing and administrative scoping, enable IGMP and PIM-SM on Router
B and Router H in the same way. (Details not shown.)
# On the firewall, enable IP multicast routing and administrative scoping, and enable PIM-SM
on each interface.
<Firewall> system-view
[Firewall] multicast routing-enable
[Firewall] pim
[Firewall-pim] c-bsr admin-scope
[Firewall-pim] quit
[Firewall] interface gigabitethernet 0/1
[Firewall-GigabitEthernet0/1] pim sm
[Firewall-GigabitEthernet0/1] quit
[Firewall] interface gigabitethernet 0/2
[Firewall-GigabitEthernet0/2] pim sm
[Firewall-GigabitEthernet0/2] quit
[Firewall] interface gigabitethernet 0/3
[Firewall-GigabitEthernet0/3] pim sm
[Firewall-GigabitEthernet0/3] quit
[Firewall] interface gigabitethernet 0/4
[Firewall-GigabitEthernet0/4] pim sm
[Firewall-GigabitEthernet0/4] quit
# Enable IP multicast routing and administrative scoping, and enable PIM-SM on Router B,
Router C, Router E, Router F, and Router G in the same way. (Details not shown.)
d. Configure an admin-scope zone boundary:
# On the firewall, configure GigabitEthernet 0/3 andGigabitEthernet 0/4 as the boundary of
admin-scope zone 1.
[Firewall] interface gigabitethernet 0/3