F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

ManualsBrandsHP ManualsComputer AccessoriesHP 7100/7200 IPsec dl Module

651

652

653

654

655

656

657

658

659

660

635

Figure 351 Network diagram

Device Interface IP address Device Interface IP address

Firewall GE0/1 10.110.1.1/24

Router C

Eth1/1

10.110.5.1/24

GE0/2 192.168.1.1/24

Eth1/2

192.168.1.2/24

GE0/3 192.168.9.1/24 POS5/0 192.168.4.2/24

Router

Eth1/1 10.110.2.1/24

Router D

POS5/0

192.168.3.2/24

POS5/0 192.168.2.1/24

POS5/1

192.168.2.2/24

Router B Eth1/1 10.110.2.2/24 Eth1/1 192.168.9.2/24

POS5/0 192.168.3.1/24

POS5/3

192.168.4.1/24

2. Configuration procedure

a. Assign an IP address and subnet mask to each interface according to 2827HFigure 351. (Details not

shown.)

b. Configure OSPF on the routers in the PIM-SSM domain to make sure they are interoperable at

the network layer. (Details not shown.)

c. Enable IP multicast routing, IGMP and PIM-SM:

# On the firewall, enable IP multicast routing globally, enable IGMPv3 on GigabitEthernet 0/1,

and enable PIM-SM on each interface.

<Firewall> system-view

[Firewall] multicast routing-enable

[Firewall] interface gigabitethernet 0/1

[Firewall-GigabitEthernet0/1] igmp enable

[Firewall-GigabitEthernet0/1] igmp version 3

[Firewall-GigabitEthernet0/1] pim sm

[Firewall-GigabitEthernet0/1] quit

[Firewall] interface gigabitethernet 0/2

GE0/2

Eth1