F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

643
Ste
p
Command Remarks
881. Enter system view. system-view N/A
882. Enter public network MSDP view.
msdp N/A
883. Configure a static RPF peer.
static-rpf-peer peer-address
[ rp-policy ip-prefix-name ]
No static RPF peer configured by
default.
NOTE:
If only one MSDP peer is configured on a router, this MSDP peer is registered as a static RPF peer.
211B
Configuring an MSDP peer connection
This section describes how to configure an MSDP peer connection.
803BConfiguration prerequisites
Before you configure an MSDP peer connection, complete the following tasks:
• Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
• Configure basic MSDP functions.
• Determine the description of MSDP peers.
• Determine the name of an MSDP mesh group.
• Determine the MSDP peer connection retry interval.
• Determine the password for MD5 authentication used by both MSDP peers to establish a TCP
connection.
804BConfiguring MSDP peer description
MSDP peer descriptions help the administrator easily distinguish different MSDP peers and better
manage MSDP peers.
To configure the description for an MSDP peer:
Ste
p
Command Remarks
884. Enter system view. system-view N/A
885. Enter public network MSDP
view.
msdp N/A
886. Configure the description for
an MSDP peer.
peer peer-address description text
No description is configured for an
MSDP peer by default.
805BConfiguring an MSDP mesh group
An AS can contain multiple MSDP peers. You can use the MSDP mesh group mechanism to avoid SA
message flooding among these MSDP peers and optimize the multicast traffic.
An MSDP peer in an MSDP mesh group forwards SA messages from outside the mesh group that passed
the RPF check to the other members in the mesh group. A mesh group member accepts SA messages from