F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

654
Figure 353 Network diagram
Device Interface IP address Device Interface IP address
Source 1 - 192.168.1.100
/
24 Firewall GE0/1 10.110.5.1
/
24
Source 2 - 192.168.3.100/24 GE0/2 10.110.3.2/24
Router
A
Eth1/1 10.110.1.1
/
24 Loop0 2.2.2.2
/
32
Eth1/2 10.110.2.1
/
24 Router D Eth1/1 10.110.5.2
/
24
Loop0 1.1.1.1/32 Eth1/2 192.168.3.1/24
Router B Eth1/1 10.110.1.2
/
24 Router E Eth1/1 10.110.6.1/24
Eth1/2 192.168.1.1/24 S2/0 10.110.4.2
/
24
Eth1/3 10.110.3.1/24 Router F Eth1/1 10.110.6.2/24
Router C Eth1/1 10.110.2.2
/
24 Eth1/2 192.168.4.1/24
Eth1/2 192.168.2.1/24 Loop0 3.3.3.3
/
32
S2/0 10.110.4.1/24
1646BConfiguration procedure
1. Assign IP addresses and configure unicast routing:
a. Assign an IP address and subnet mask to each interface according to 2844HFigure 353. (Details not
shown.)
b. Configure OSPF on the routers to make sure the routers are interoperable at the network layer
in each AS, and they can dynamically update routing information. (Details not shown.)
2. Enable IP multicast routing, PIM-SM, and IGMP, and configure a PIM-SM domain border:
# on Router C, enable IP multicast routing globally, enable PIM-SM on each interface, and enable
IGMP on the host-side interface Ethernet 1/2.
<RouterC> system-view
[RouterC] multicast routing-enable
[RouterC] interface ethernet 1/1
[RouterC-Ethernet1/1] pim sm
[RouterC-Ethernet1/1] quit
Eth1/3
S
2
/
0
Router B
Router A
Source 1
AS 100
PIM-SM 1
PIM-SM 3
PIM-SM 2
Loop0
Firewall Router D
Router E
Router F
Source 2
Eth1/2
Eth1/1
GE0/2 GE0/1
Eth1/1
Loop0
Receiver
Receiver
Loop0
BGP peers
Eth1
/1
Eth1/1
Eth1/1
Eth1/2
Eth1
/2
AS 200
S
2
/
0
Eth1/1
Eth1/2
Eth1/2
Router C