F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

659
[RouterB] interface serial 2/0
[RouterB-Serial2/0] pim sm
[RouterB-Serial2/0] quit
[RouterB] interface pos 5/0
[RouterB-Pos5/0] pim sm
[RouterB-Pos5/0] quit
[RouterB] interface loopback 0
[RouterB-LoopBack0] pim sm
[RouterB-LoopBack0] quit
[RouterB] interface loopback 10
[RouterB-LoopBack10] pim sm
[RouterB-LoopBack10] quit
[RouterB] interface loopback 20
[RouterB-LoopBack20] pim sm
[RouterB-LoopBack20] quit
# Enable IP multicast routing, IGMP, and PIM-SM on Router A, Router C, the firewall, and Router
D in the same way. (Details not shown.)
3. Configure C-BSRs and C-RPs:
# Configure Loopback 10 as a C-BSR and configure Loopback 20 as a C-RP on Router B.
[RouterB] pim
[RouterB-pim] c-bsr loopback 10
[RouterB-pim] c-rp loopback 20
[RouterB-pim] quit
# Configure a C-BSR and a C-RP on the firewall in the same way. (Details not shown.)
4. Configure MSDP peers:
# Configure an MSDP peer on Loopback 0 of Router B.
[RouterB] msdp
[RouterB-msdp] originating-rp loopback 0
[RouterB-msdp] peer 2.2.2.2 connect-interface loopback 0
[RouterB-msdp] quit
# Configure an MSDP peer on Loopback 0 of the firewall.
[Firewall] msdp
[Firewall-msdp] originating-rp loopback 0
[Firewall-msdp] peer 1.1.1.1 connect-interface loopback 0
[Firewall-msdp] quit
1650BVerifying the configuration
# Display brief information about MSDP peers on Router B.
[RouterB] display msdp brief
MSDP Peer Brief Information of VPN-Instance: public net
Configured Up Listen Connect Shutdown Down
1 1 0 0 0 0
Peer's Address State Up/Down time AS SA Count Reset Count
2.2.2.2 Up 00:10:17 ? 0 0
# Display brief information about MSDP peers on the firewall.
[Firewall] display msdp brief