F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

662
Figure 355 Network diagram
Device Interface IP address Device Interface IP address
Source 1 — 10.110.3.100/24 Router C Eth1/1 10.110.4.1/24
Source 2 — 10.110.6.100/24 Eth1/2 10.110.5.1/24
Router A Eth1/1 10.110.1.1/24 POS5/1 192.168.1.2/24
S2/1 10.110.2.1/24 POS5/2 192.168.2.2/24
POS5/1 192.168.1.1/24 Loop0 2.2.2.2/32
Loop0 1.1.1.1/32 Firewall GE0/1 10.110.6.1/24
Router B Eth1/1 10.110.3.1/24 GE0/2 10.110.7.1/24
S2/1 10.110.2.2/24 GE0/3 10.110.5.2/24
POS5/1 192.168.2.1/24 Loop0 3.3.3.3/32
1652BConfiguration procedure
1. Assign IP addresses and configure unicast routing:
a. Assign the IP address and subnet mask to each interface according to 2848HFigure 355. (Details not
shown.)
b. Configure OSPF on the routers in the PIM-SM domains to make sure the routers are
interoperable at the network layer and they can dynamically update routing information.
(Details not shown.)
2. Enable IP multicast routing, IGMP, and PIM-SM, and configure a PIM domain border:
# On Router A, enable IP multicast routing globally, enable IGMP on the host-side interface,
Ethernet 1/1, and enable PIM-SM on each interface.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] igmp enable
[RouterA-Ethernet1/1] pim sm
[RouterA-Ethernet1/1] quit
[RouterA] interface serial 2/1
[RouterA-Serial2/1] pim sm
MSDP peers
PIM-SM 1 PIM-SM 2 PIM-SM 3
Loop0
Loop0
Source 1
Source 2
Receiver
Host B
Receiver
Host C
Receiver
Host A
Eth1/1
Eth1/1
Eth1/1 GE0/2
S2/1
S2/1
P
O
S
5
/
1
P
O
S
5
/
1
P
O
S
5
/
1
P
O
S
5
/
2
Eth1/2
GE0/3
GE0/1
Router A
Router C
Firewall
Router B