F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

696
InMcastNotMembers: 0
OutMcastPkts: 7
InAddrErrors: 0
InDiscards: 0
OutDiscards: 0
# Ping Firewall A and Firewall B from the host, and ping Firewall A and the host from Firewall B to verify
that they are connected.
CAUTION:
W
hen you pin
g
a link-local address, you should use the "–i" parameter to specify an interface for the
link-local address.
[FirewallB] ping ipv6 -c 1 3001::1
PING 3001::1 : 56 data bytes, press CTRL_C to break
Reply from 3001::1
bytes=56 Sequence=1 hop limit=64 time = 2 ms
--- 3001::1 ping statistics ---
1 packet(s) transmitted
1 packet(s) received
0.00% packet loss
round-trip min/avg/max = 2/2/2 ms
[FirewallB-GigabitEthernet0/1] ping ipv6 -c 1 2001::15B:E0EA:3524:E791
PING 2001::15B:E0EA:3524:E791 : 56 data bytes, press CTRL_C to break
Reply from 2001::15B:E0EA:3524:E791
bytes=56 Sequence=1 hop limit=63 time = 3 ms
--- 2001::15B:E0EA:3524:E791 ping statistics ---
1 packet(s) transmitted
1 packet(s) received
0.00% packet loss
round-trip min/avg/max = 3/3/3 ms
The output shows that Firewall B can ping Firewall A and the host.
227B
Troubleshooting IPv6 basics configuration
846BSymptom
The peer IPv6 address cannot be pinged.
847BSolution
1. Use the display current-configuration command in any view or the display this command in system
view to verify that IPv6 is enabled. For more information about the display current-configuration
command, see System Management and Maintenance Configuration Guide.
2. Use the display ipv6 interface command in any view to verify that the IPv6 address of the interface
is correct and the interface is up.