F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

731
258B
Displaying and maintaining the DHCPv6 client
Task Command Remarks
Display DHCPv6 client
information.
display ipv6 dhcp client [ interface interface-type
interface-number ] [ | { begin | exclude | include }
regular-expression ]
Available in any view.
Display DHCPv6 client
statistics.
display ipv6 dhcp client statistics [ interface
interface-type interface-number ] [ | { begin | exclude
| include } regular-expression ]
Available in any view.
Display the DUID of the
local device.
display ipv6 dhcp duid [ | { begin | exclude | include }
regular-expression ]
Available in any view.
Clear DHCPv6 client
statistics.
reset ipv6 dhcp client statistics [ interface interface-type
interface-number ]
Available in user view.
259B
DHCPv6 client configuration examples
867BIPv6 prefix acquisition configuration example
1716BNetwork requirements
The DHCPv6 client Firewall uses DHCPv6 to obtain an IPv6 prefix, the DNS server address, domain
name suffix, SIP server address, and domain name of the SIP server.
Configure the client to create an IPv6 prefix based on the obtained prefix and create a DHCPv6 option
group for the obtained configuration parameters.
Figure 379 Network diagram
1717BConfiguration procedure
Before you make the following configuration, configure the DHCPv6 server. For information about
DHCPv6 server, see "
2908HConfiguring the DHCPv6 server."
# Enable IPv6.
<Firewall> system-view
[Firewall] ipv6
# Configure the IP address of GigabitEthernet 0/1.