F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

752
• Define an IPv6 ACL before using it for route filtering. For related information, see Access Control
Configuration Guide.
• Define an IPv6 address prefix list before using it for route filtering. For related information, see
"Configuring routing policies."
881BConfiguring an additional routing metric
An additional routing metric can be added to the metric of an inbound or outbound RIP route.
The outbound additional metric is added to the metric of a sent route. The route's metric in the routing
table is not changed.
The inbound additional metric is added to the metric of a received route before the route is added into
the routing table, so the route's metric is changed.
To configure an inbound or outbound additional routing metric:
Ste
p
Command Remarks
1052. Enter system view.
system-view N/A
1053. Enter interface view.
interface interface-type interface-number N/A
1054. Specify an inbound
routing additional metric.
ripng metricin value
Optional.
0 by default.
1055. Specify an outbound
routing additional metric.
ripng metricout value
Optional.
1 by default.
882BConfiguring RIPng route summarization
Ste
p
Command
1056. Enter system view.
system-view
1057. Enter interface view.
interface interface-type interface-number
1058. Advertise a summary IPv6 prefix.
ripng summary-address ipv6-address prefix-length
883BAdvertising a default route
With this feature enabled, a default route is advertised through the specified interface regardless of
whether the default route is available in the local IPv6 routing table.
To advertise a default route:
Ste
p
Command Remarks
1059. Enter system view.
system-view N/A
1060. Enter interface view.
interface interface-type interface-number N/A
1061. Advertise a default
route.
ripng default-route { only | originate } [ cost
cost ]
Not advertised by default.