F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

759
Dest 1::/64,
via FE80::20F:E2FF:FE23:82F5, cost 1, tag 0, A, 2 Sec
Dest 2::/64,
via FE80::20F:E2FF:FE23:82F5, cost 1, tag 0, A, 2 Sec
Peer FE80::20F:E2FF:FE00:100 on GigabitEthernet0/2
Dest 4::/64,
via FE80::20F:E2FF:FE00:100, cost 1, tag 0, A, 5 Sec
Dest 5::/64,
via FE80::20F:E2FF:FE00:100, cost 1, tag 0, A, 5 Sec
[Firewall] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::20F:E2FF:FE00:1235 on GigabitEthernet0/1
Dest 1::/64,
via FE80::20F:E2FF:FE00:1235, cost 1, tag 0, A, 2 Sec
Dest 4::/64,
via FE80::20F:E2FF:FE00:1235, cost 2, tag 0, A, 2 Sec
Dest 5::/64,
via FE80::20F:E2FF:FE00:1235, cost 2, tag 0, A, 2 Sec
892BConfiguring RIPng route redistribution
1731BNetwork requirements
• Firewall runs two RIPng processes. It communicates with Router A through RIPng 100 and with
Router B through RIPng 200.
• Configure route redistribution on Firewall, allowing the two RIPng processes to redistribute routes
from each other. Set the default cost of redistributed routes from RIPng 200 to 3.
Figure 390 Network diagram
1732BConfiguration procedure
1. Configure IPv6 addresses for the interfaces. (Details not shown.)
2. Configure RIPng basic functions:
# Enable RIPng 100 on Router A.
<RouterA> system-view
[RouterA] ripng 100
[RouterA-ripng-100] quit
[RouterA] interface gigabitethernet 0/1
[RouterA-GigabitEthernet0/1] ripng 100 enable