F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

766
Task Remarks
2938H
Configuring OSPFv3
routing information
control
2939H
Configuring OSPFv3 route summarization Optional
2940H
Configuring OSPFv3 inbound route filtering Optional
2941H
Configuring an OSPFv3 cost for an interface Optional
2942H
Configuring the maximum number of OSPFv3 ECMP routes Optional
2943H
Configuring a priority for OSPFv3 Optional
2944H
Configuring OSPFv3 route redistribution Optional
2945H
Tuning and optimizing
OSPFv3 networks
2946H
Configuring OSPFv3 timers Optional
2947H
Configuring a DR priority for an interface Optional
2948H
Ignoring MTU check for DD packets Optional
2949H
Disabling interfaces from receiving and sending OSPFv3
packets
Optional
2950H
Enabling the logging of neighbor state changes Optional
2951H
Configuring BFD for OSPFv3 Optional
2952H
Applying IPsec policies for OSPFv3 Optional
283B
Enabling OSPFv3
894BConfiguration prerequisites
Before you enable OSPFv3, complete the following tasks:
• Make neighboring nodes accessible with each other at the network layer.
• Enable IPv6 packet forwarding.
895BEnabling OSPFv3
To enable an OSPFv3 process on a router, you must enable the OSPFv3 process globally, assign the
OSPFv3 process a router ID, and enable the OSPFv3 process on related interfaces.
A router ID uniquely identifies a router within an AS. You must specify a unique router ID for each OSPFv3
router within the AS to ensure proper operation. If a router runs multiple OSPFv3 processes, specify a
unique router ID for each process.
An OSPFv3 process ID has only local significance. Process 1 on a router can exchange packets with
process 2 on another router.
To enable OSPFv3:
Ste
p
Command Remarks
1094. Enter system view.
system-view N/A
1095. Enable an OSPFv3
process and enter its view.
ospfv3 [ process-id ] [ vpn-instance
vpn-instance-name ]
By default, no OSPFv3 process is
enabled.
1096. Specify a router ID.
router-id router-id N/A