F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

767
Ste
p
Command Remarks
1097. Enter interface view.
interface interface-type
interface-number
N/A
1098. Enable an OSPFv3
process on the interface.
ospfv3 process-id area area-id
[ instance instance-id ]
Not enabled by default.
284B
Configuring OSPFv3 area parameters
The stub area and virtual link features of OSPFv3 are the same as OSPFv2.
Splitting an OSPFv3 AS into multiple areas reduces the number of LSAs and extends OSPFv3
applications. For those non-backbone areas residing on the AS boundary, configure them as stub areas
to further reduce the size of routing tables and the number of LSAs.
Non-backbone areas exchange routing information through the backbone area. The backbone and
non-backbone areas (including the backbone itself) must be contiguous. In practice, necessary physical
links might not be available for this connectivity. You can configure virtual links to address this issue.
896BConfiguration prerequisites
Before you configure OSPFv3 area parameters, complete the following tasks:
• Enable IPv6 packet forwarding.
• Configure OSPFv3 basic functions.
897BConfiguring an OSPFv3 stub area
Follow these guidelines when you configure an OSPFv3 stub area:
• You cannot remove an OSPFv3 area directly. The area can be removed only when you remove all
configurations in area view and all interfaces attached to the area become down.
• All the routers attached to a stub area must be configured with the stub command. The keyword
no-summary is only available on the ABR of the stub area.
• If you use the stub command with the keyword no-summary on an ABR, the ABR advertises a
default route in an Inter-Area-Prefix-LSA into the stub area. No AS-external-LSA,
Inter-Area-Router-LSA, or other Inter-Area-Prefix-LSA is advertised in the area. The stub area of this
kind is also known as a "totally stub area."
To configure an OSPFv3 stub area:
Ste
p
Command Remarks
1099. Enter system view. system-view N/A
1100. Enter OSPFv3 view.
ospfv3 [ process-id ] N/A
1101. Enter OSPFv3 area view.
area area-id N/A
1102. Configure the area as a stub
area.
stub [ no-summary ] Not configured by default.
1103. Specify a cost for the default
route advertised to the stub area.
default-cost value
Optional.
The cost for the default route
advertised to the stub area is1.