F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

769
Ste
p
Command Remarks
1109. Enter interface
view.
interface interface-type interface-number N/A
1110. Configure a
network type for the
OSPFv3 interface.
ospfv3 network-type { broadcast | nbma
| p2mp [ non-broadcast ] | p2p }
[ instance instance-id ]
Optional.
The network type of an interface
depends on the media type of the
interface.
901BConfiguring an NBMA or P2MP neighbor
For NBMA and P2MP interfaces (only when in unicast mode), you must specify the link-local IP addresses
of their neighbors because these interfaces cannot find neighbors through broadcasting hello packets.
You can also specify DR priorities for neighbors.
To configure an NBMA or P2MP (unicast) neighbor and its DR priority:
Ste
p
Command
1111. Enter system view.
system-view
1112. Enter interface view. interface interface-type interface-number
1113. Specify an NBMA or P2MP
(unicast) neighbor and its DR priority.
ospfv3 peer ipv6-address [ dr-priority dr-priority ] [ instance
instance-id ]
286B
Configuring OSPFv3 routing information control
This section describes how to configure the control of OSPF routing information advertisement and
reception, and redistribution from other protocols.
902BConfiguration prerequisites
Before you configure OSPFv3 routing information control, complete the following tasks:
• Enable IPv6 packet forwarding.
• Configure OSPFv3 basic functions.
903BConfiguring OSPFv3 route summarization
If contiguous network segments exist in an area, you can use the abr-summary command to summarize
them into one network segment on the ABR. The ABR will advertise only the summary route. Any LSA
falling into the specified network segment will not be advertised, reducing the LSDB size in other areas.
To configure route summarization:
Ste
p
Command Remarks
1114. Enter system view. system-view N/A
1115. Enter OSPFv3 view.
ospfv3 [ process-id ] N/A
1116. Enter OSPFv3 area
view.
area area-id N/A