F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

791
# Display the BFD information of Firewall A.
<FirewallA> display bfd session
The output shows that Firewall A has removed its neighbor relationship with Firewall B and therefore no
information is output.
# Display routes destined for 2001:4::0/64 on Firewall A.
<FirewallA> display ipv6 routing-table 2001:4::0 64 verbose
Routing Table :
Summary Count : 1
Destination : 2001:4:: PrefixLength : 64
NextHop : 2001:2::2 Preference : 10
IpPrecedence : QosLcId :
RelayNextHop : :: Tag : 0H
Neighbor : :: ProcessID : 0
Interface : GigabitEthernet1/2 Protocol : OSPFv3
State : Active Adv Cost : 2
Tunnel ID : 0x0 Label : NULL
Age : 4610sec
The output shows that Firewall A communicates with Firewall B through Router.
919BConfiguring OSPFv3 IPsec policies
1746BNetwork requirements
As shown in 2957HFigure 396,
• Configure OSPFv3 on the devices. The AS is divided into two areas.
• Configure IPsec policies on the devices to authenticate and encrypt protocol packets.
Figure 396 Network diagram
1747BConfiguration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure OSPFv3 basic functions:
# Configure Router A: enable OSPFv3 and configure the Router ID as 1.1.1.1.
<RouterA> system-view
[RouterA] ipv6
[RouterA] ospfv3 1