F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

805
Task Remarks
2963H
Specifying the source interface for establishing TCP connections Optional
2964H
Allowing the establishment of an indirect EBGP connection Optional
2965H
Configuring a description for an IPv6 peer or peer group Optional
2966H
Disabling session establishment to an IPv6 peer or peer group Optional
2967H
Logging IPv6 peer or peer group state changes Optional
2968H
Controlling route
distribution and
reception
2969H
Configuring IPv6 BGP route redistribution Optional
2970H
Configuring IPv6 BGP route summarization Optional
2971H
Advertising a default route to an IPv6 peer or peer group Optional
2972H
Configuring outbound route filtering Optional
2973H
Configuring inbound route filtering Optional
2974H
Configuring IPv6 BGP and IGP route synchronization Optional
2975H
Configuring route dampening Optional
2976H
Configuring IPv6
BGP route
attributes
2977H
Configuring IPv6 BGP preference and default LOCAL_PREF and
NEXT_HOP attributes
Optional
2978H
Configuring the MED attribute Optional
2979H
Configuring the AS_PATH attribute Optional
2980H
Tuning and
optimizing IPv6
BGP networks
2981H
Configuring IPv6 BGP timers Optional
2982H
Configuring IPv6 BGP soft reset Optional
2983H
Enabling the IPv6 BGP ORF capability Optional
2984H
Enabling 4-byte AS number suppression Optional
2985H
Configuring the maximum number of ECMP routes Optional
2986H
Enabling MD5 authentication for TCP connections Optional
2987H
Applying an IPsec policy to an IPv6 BGP peer or peer group Optional
2988H
Configuring a
large-scale IPv6
BGP network
2989H
Configuring IPv6 BGP peer group Optional
2990H
Configuring IPv6 BGP community Optional
2991H
Configuring an IPv6 BGP route reflector Optional
2992H
Configuring BFD for IPv6 BGP Optional
302B
Configuring IPv6 BGP basic functions
925BConfiguration prerequisites
Before you configure IPv6 BGP basic functions, complete the following tasks:
• Specify IP addresses for interfaces.
• Enable IPv6 with the ipv6 command in system view.
• Create a peer group before configuring basic functions for it. For related information, see
"
2993HConfiguring IPv6 BGP peer group."