F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

806
926BSpecifying an IPv6 BGP peer
Ste
p
Command Remarks
1197. Enter system view.
system-view N/A
1198. Enter BGP view.
bgp as-number N/A
1199. Specify a router ID.
router-id router-id
Optional.
Required, if no IP addresses are
configured for any interfaces.
1200. Enter IPv6 address
family view or IPv6 BGP-VPN
instance view.
ipv6-family [ vpn-instance
vpn-instance-name ]
N/A
1201. Specify an IPv6 peer.
peer ipv6-address as-number
as-number
N/A
927BInjecting a local IPv6 route
Ste
p
Command Remarks
1202. Enter system view.
system-view N/A
1203. Enter BGP view. bgp as-number N/A
1204. Enter IPv6 address family
view or IPv6 BGP-VPN instance
view.
ipv6-family [ vpn-instance
vpn-instance-name ]
N/A
1205. Inject a local route into the
IPv6 BGP routing table.
network ipv6-address prefix-length
[ route-policy route-policy-name | short-cut ]
Not added by
default.
928BConfiguring a preferred value for routes from a peer or peer
group
If you both reference a routing policy and use the command peer { ipv6-group-name | ipv6-address }
preferred-value value to set a preferred value for routes from a peer, the routing policy sets the specific
preferred value for routes matching it. If the preferred value in the routing policy is zero, the routes use the
value set with the peer { ipv6-group-name | ipv6-address } preferred-value value command. For how to
use a routing policy to set a preferred value, see the command peer { group-name | ipv4-address |
ipv6-address } route-policy route-policy-name { import | export } in this document, and the command
apply preferred-value preferred-value in Network Management Command Reference.
To configure a preferred value for routes received from a peer or peer group:
Ste
p
Command Remarks
1206. Enter system view.
system-view N/A
1207. Enter BGP view.
bgp as-number N/A
1208. Enter IPv6 address
family view or IPv6 BGP-VPN
instance view.
ipv6-family [ vpn-instance
vpn-instance-name ]
N/A