F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

812
IGP route with the same destination network segment before it can advertise the IBGP route (use the
display ipv6 routing-table protocol command to check the IGP route state).
To configure IPv6 BGP and IGP route synchronization:
Ste
p
Command Remarks
1261. Enter system view.
system-view N/A
1262. Enter BGP view.
bgp as-number N/A
1263. Enter IPv6 address family view. ipv6-family N/A
1264. Enable route synchronization
between IPv6 BGP and IGP.
synchronization Not enabled by default.
941BConfiguring route dampening
Ste
p
Command Remarks
1265. Enter system view. system-view N/A
1266. Enter BGP view.
bgp as-number N/A
1267. Enter IPv6 address
family view.
ipv6-family N/A
1268. Configure IPv6 BGP
route dampening parameters.
dampening [ half-life-reachable
half-life-unreachable reuse suppress ceiling |
route-policy route-policy-name ]*
Optional.
Not configured by
default.
304B
Configuring IPv6 BGP route attributes
This section describes how to use IPv6 BGP route attributes to modify BGP routing policy. The attributes
include the following:
• IPv6 BGP protocol preference
• Default LOCAL_PREF attribute
• MED attribute
• NEXT_HOP attribute
• AS_PATH attribute
942BConfiguration prerequisites
Before you configure IPv6 BGP route attributes, complete the following tasks:
• Enable IPv6 function.
• Configure IPv6 BGP basic functions.