F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

816
Ste
p
Command Remarks
1294. Configure the interval
for sending the same update
to an IPv6 peer or peer
group.
peer { ipv6-group-name |
ipv6-address }
route-update-interval interval
Optional.
The interval for sending the same
update to an IBGP peer or an EBGP
peer defaults to 15 seconds or 30
seconds.
948BConfiguring IPv6 BGP soft reset
1756BEnabling route refresh
Ste
p
Command Remarks
1295. Enter system view.
system-view N/A
1296. Enter BGP view.
bgp as-number N/A
1297. Enter IPv6 address family
view.
ipv6-family N/A
1298. Enable route refresh.
peer { ipv6-group-name | ipv6-address }
capability-advertise route-refresh
Optional.
Enabled by default.
1757BPerforming manual soft-reset
Ste
p
Command Remarks
1299. Enter system view.
system-view N/A
1300. Enter BGP view. bgp as-number N/A
1301. Enter IPv6 address
family view.
ipv6-family N/A
1302. Save all routes from an
IPv6 peer or peer group, not
letting them go through the
inbound policy.
peer { ipv6-group-name | ipv6-address }
keep-all-routes
Optional.
Not saved by default.
1303. Return to user view.
return N/A
1304. Soft-reset BGP
connections manually.
refresh bgp ipv6 { all | ipv6-address | group
ipv6-group-name | external | internal } { export
| import }
N/A
NOTE:
If the peer keep-all-routes command is used, all routes from the peer or peer group are saved re
g
ardless
of whether the filtering policy is available. These routes will be used to generate IPv6 BGP routes after
soft-reset is performed.
949BEnabling the IPv6 BGP ORF capability
The BGP Outbound Route Filter (ORF) feature allows a BGP speaker to send its BGP peer a set of ORFs
through route-refresh messages. The peer then applies the ORFs, in addition to its local routing policies