F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

833
Optional capabilities:
Route refresh capability has been enabled
ORF advertise capability based on prefix (type 64):
Local: both
Negotiated: send
Peer Preferred Value: 0
IPsec policy name: policy002, SPI :54321
Routing policy configured:
No routing policy is configured
The output shows that both IBGP and EBGP neighbor relationships have been established, and all
protocol packets are protected by IPsec.
964BBFD for IPv6 BGP configuration example
The following matrix shows the configuration example and hardware compatibility:
Hardware Exam
p
le a
pp
licable
F1000-A-EI/F1000-S-EI No
F1000-E No
F5000 Yes
Firewall module No
U200-A No
U200-S No
1771BNetwork requirements
• As shown in 2998HFigure 401, configure OSPFv3 as the IGP in AS 200.
• Establish two IBGP connections between Firewall A and Firewall B. When both links are working,
Firewall B adopts the link Firewall A<—>Router A<—>Firewall B to exchange packets with network
1200::0/64. Configure BFD over the link. Then if the link fails, BFD can quickly detect the failure
and notify it to IPv6 BGP. Then the link Firewall A<—>Router B<—>Firewall B takes effect
immediately.
Figure 401 Network diagram