F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

835
[FirewallB-bgp-af-ipv6] peer 3001::1 as-number 200
[FirewallB-bgp-af-ipv6] peer 3001::1 bfd
[FirewallB-bgp-af-ipv6] peer 2001::1 as-number 200
[FirewallB-bgp-af-ipv6] quit
[FirewallB-bgp] quit
5. Configure BFD parameters (you can use default BFD parameters instead):
# Configure Firewall A.
[FirewallA] bfd session init-mode active
[FirewallA] interface gigabitethernet 1/2
{ Configure the minimum interval for transmitting BFD control packets as 500 milliseconds.
[FirewallA-GigabitEthernet1/2] bfd min-transmit-interval 500
{ Configure the minimum interval for receiving BFD control packets as 500 milliseconds.
[FirewallA-GigabitEthernet1/2] bfd min-receive-interval 500
{ Configure the detect multiplier as 7.
[FirewallA-GigabitEthernet1/2] bfd detect-multiplier 7
{ Configure the BFD authentication mode as plain-text authentication, and set the authentication
key to ibgpbfd.
[FirewallA-GigabitEthernet1/2] bfd authentication-mode simple 1 ibgpbfd
[FirewallA-GigabitEthernet1/2] quit
# Configure Firewall B.
[FirewallB] bfd session init-mode active
[FirewallB] interface gigabitethernet 1/1
{ Configure the minimum interval for transmitting BFD control packets as 500 milliseconds.
[FirewallB-GigabitEthernet1/1] bfd min-transmit-interval 500
{ Configure the minimum interval for receiving BFD control packets as 500 milliseconds.
[FirewallB-GigabitEthernet1/1] bfd min-receive-interval 500
{ Configure the detect multiplier as 7.
[FirewallB-GigabitEthernet1/1] bfd detect-multiplier 7
{ Configure the BFD authentication mode as plain-text authentication, and set the authentication
key to ibgpbfd.
[FirewallB-GigabitEthernet1/1] bfd authentication-mode simple 1 ibgpbfd
[FirewallB-GigabitEthernet1/1] return
6. Verify the configuration:
# Display detailed BFD session information on Firewall B.
<FirewallB> display bfd session verbose
Total Session Num: 1 Init Mode: Active
IPv6 Session Working Under Ctrl Mode:
Local Discr: 17 Remote Discr: 13
Source IP: 3002::2
Destination IP: 3001::1
Session State: Up Interface: GigabitEthernet1/1
Min Trans Inter: 500ms Act Trans Inter: 500ms
Min Recv Inter: 500ms Act Detect Inter: 3000ms