F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

843
Ste
p
Command Remarks
1370. Enter IPv6 policy node
view.
ipv6 policy-based-route policy-name
[ deny | permit ] node node-number
Not created by default.
1371. Set a preference type or
value for permitted IPv6
packets.
apply ipv6-precedence { type |
value }
Optional.
1372. Set an output interface
for permitted IPv6 packets.
apply output-interface interface-type
interface-number
Optional.
You can specify up to five output
interfaces to achieve load
sharing.
1373. Set a next hop for
permitted IPv6 packets.
apply ipv6-address next-hop
ipv6-address
Optional.
You can define five next hops at
most for load balancing.
1374. Set a default output
interface for permitted IPv6
packets.
apply default output-interface
interface-type interface-number
Optional.
You can specify up to five output
interfaces to achieve load
sharing.
1375. Set a default next hop
for permitted IPv6 packets.
apply ipv6-address default next-hop
ipv6-address
Optional.
You can specify up to five output
interfaces to achieve load
sharing.
NOTE:
If a local Ethernet interface or sub Ethernet interface is specified as the output interface, packets can be
forwarded through the interface but the forwarding may fail, because the interface is a broadcast
interface. You need to specify a next hop.
316B
Configuring IPv6 PBR
971BConfiguring IPv6 local PBR
Configure IPv6 PBR by applying a policy locally. IPv6 PBR uses the policy to guide the forwarding of
locally generated packets.
You can apply only one policy locally. If you perform the ipv6 local policy-based-route command
multiple times, only the last specified policy takes effect.
Do not configure IPv6 local PBR unless required.
If the specified policy does not exist, the IPv6 local PBR configuration succeeds, but it does not takes effect
until the policy is created.
To configure IPv6 local PBR:
Ste
p
Command Remarks
1376. Enter system view.
system-view N/A
1377. Apply an IPv6 policy
locally.
ipv6 local policy-based-route policy-name Not applied by default.