F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

844
972BConfiguring IPv6 interface PBR
Configure PBR by applying an IPv6 policy on an interface. IPv6 PBR uses the policy to guide the
forwarding of packets received on the interface.
You can apply only one policy on an interface. If you perform the ipv6 policy-based-route command
multiple times, only the last specified policy takes effect.
You can apply the same IPv6 policy on multiple interfaces.
If the specified policy does not exist, the IPv6 interface PBR configuration succeeds, but it does not take
effect until the policy is created.
To configure IPv6 interface PBR:
Ste
p
Command Remarks
1378. Enter system view.
system-view N/A
1379. Enter interface view.
interface interface-type
interface-number
N/A
1380. Apply an IPv6 policy on the
interface.
ipv6 policy-based-route
policy-name
Not applied by default.
317B
Displaying and maintaining IPv6 PBR configuration
Task Command Remarks
Display information about IPv6
local PBR and IPv6 interface PBR.
display ipv6 policy-based-route [ | { begin |
exclude | include } regular-expression ]
Available in any view.
Display IPv6 PBR configuration.
display ipv6 policy-based-route setup
{ policy-name | interface interface-type
interface-number | local } [ | { begin |
exclude | include } regular-expression ]
Available in any view.
Display IPv6 PBR statistics.
display ipv6 policy-based-route statistics
{ interface interface-type interface-number |
local } [ | { begin | exclude | include }
regular-expression ]
Available in any view.
Display IPv6 PBR policy.
display ipv6 config policy-based-route
[ policy-name ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Clear IPv6 PBR statistics. reset ipv6 policy-based-route statistics Available in user view.