F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

846
[RouterB] ipv6
[RouterB] interface gigabitethernet 0/2
[RouterB-GigabitEthernet0/2] ipv6 address 2::2 64
4. Verify the configuration:
# Telnet to Router A (1::2/64) from Firewall. The operation succeeds.
# Telnet to Router B (2::2/64) from Firewall. The operation fails.
# Ping Router B (2::2/64) from Firewall. The operation succeeds.
Telnet uses TCP, and ping uses ICMP. The preceding results indicate that all TCP packets of
Firewall are forwarded to the next hop 1::2, and other packets are forwarded via GigabitEthernet
0/2. The IPv6 local PBR configuration is effective.
974BConfiguring IPv6 interface PBR based on packet type
1781BNetwork requirements
As shown in 3008HFigure 403, configure IPv6 interface PBR on Firewall to forward all TCP packets received on
GigabitEthernet 0/3 via GigabitEthernet 0/1. Router A forwards other IPv6 packets according to the
routing table.
Figure 403 Network diagram
1782BConfiguration procedure
1. Configure Firewall:
# Configure RIPng.
<Firewall> system-view
[Firewall] ipv6
[Firewall] ripng 1
[Firewall-ripng-1] quit
[Firewall] interface gigabitethernet 0/1
[Firewall-GigabitEthernet0/1] ipv6 address 1::1 64