F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

847
[Firewall-GigabitEthernet0/1] ripng 1 enable
[Firewall-GigabitEthernet0/1] quit
[Firewall] interface gigabitethernet0/2
[Firewall-GigabitEthernet0/2] ipv6 address 2::1 64
[Firewall-GigabitEthernet0/2] ripng 1 enable
[Firewall-GigabitEthernet0/2] quit
# Configure ACL 3001 to match TCP packets.
[Firewall] acl ipv6 number 3001
[Firewall-acl6-adv-3001] rule permit tcp
[Firewall-acl6-adv-3001] quit
# Configure Node 5 for policy aaa to forward TCP packets via GigabitEthernet 0/1.
[Firewall] ipv6 policy-based-route aaa permit node 5
[Firewall-pbr6-aaa-5] if-match acl6 3001
[Firewall-pbr6-aaa-5] apply ipv6-address next-hop 1::2
[Firewall-pbr6-aaa-5] quit
# Configure IPv6 interface PBR by applying the policy aaa on GigabitEthernet 0/3.
[Firewall] interface gigabitethernet 0/3
[Firewall-GigabitEthernet0/3] ipv6 address 10::2 64
[Firewall-GigabitEthernet0/3] undo ipv6 nd ra halt
[Firewall-GigabitEthernet0/3] ripng 1 enable
[Firewall-GigabitEthernet0/3] ipv6 policy-based-route aaa
2. Configure RIPng for Router B.
<RouterB> system-view
[RouterB] ipv6
[RouterB] ripng 1
[RouterB-ripng-1] quit
[RouterB] interface gigabitethernet 0/1
[RouterB-GigabitEthernet0/1] ipv6 address 1::2 64
[RouterB-GigabitEthernet0/1] ripng 1 enable
3. Configure RIPng for Router A.
<RouterA> system-view
[RouterA] ipv6
[RouterA] ripng 1
[RouterA-ripng-1] quit
[RouterA] interface gigabitethernet 0/2
[RouterA-GigabitEthernet0/2] ipv6 address 2::2 64
[RouterC-GigabitEthernet0/2] ripng 1 enable
4. Verify the configuration:
Enable IPv6 and configure the IPv6 address 10::3 for Host A.
C:\>ipv6 install
Installing...
Succeeded.
C:\>ipv6 adu 4/10::3
On Host A, Telnet to Router B that is directly connected to Router A. The operation succeeds.
On Host A, Telnet to Router A that is directly connected to Router A. The operation fails.
Ping Router A from Host A. The operation succeeds.