F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

865
• Enable IPv6 forwarding and configure an IPv6 unicast routing protocol so that all devices in the
domain are interoperable at the network layer.
• Determine the IP address of a static RP and the ACL rule defining the range of IPv6 multicast groups
to be served by the static RP.
• Determine the C-RP priority and the ACL rule defining the range of IPv6 multicast groups to be
served by each C-RP.
• Determine the legal C-RP address range and the ACL rule defining the range of IPv6 multicast
groups to be served.
• Determine the C-RP-Adv interval.
• Determine the C-RP timeout timer.
• Determine the C-BSR priority.
• Determine the hash mask length.
• Determine the IPv6 ACL rule defining a legal BSR address range.
• Determine the BS period.
• Determine the BS timeout timer.
• Determine the IPv6 ACL rule for register message filtering.
• Determine the register suppression time.
• Determine the register probe time.
• Determine the IPv6 multicast traffic rate threshold, IPv6 ACL rule, and sequencing rule for initiating
an SPT switchover.
• Determine the interval for checking the IPv6 multicast traffic rate threshold before initiating an SPT
switchover.
988BEnabling IPv6 PIM-SM
With IPv6 PIM-SM enabled, a router sends hello messages periodically to discover IPv6 PIM neighbors
and processes messages from the IPv6 PIM neighbors. When you deploy an IPv6 PIM-SM domain,
enable IPv6 PIM-SM on all non-border interfaces of the routers.
IMPORTANT:
A
ll the interfaces on a device must be enabled with the same IPv6 PIM mode.
To enable IPv6 PIM-SM:
Ste
p
Command Remarks
1407. Enter system view.
system-view N/A
1408. Enable IPv6 multicast
routing.
multicast ipv6 routing-enable Disabled by default.
1409. Enter interface view.
interface interface-type interface-number N/A
1410. Enable IPv6 PIM-SM. pim ipv6 sm Disabled by default.