F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

873
Configure a filtering rule for register messages on all C-RP routers and configure them to calculate the
checksum based on the entire register messages. Configure the register suppression time and the register
probe time on all routers that might become IPv6 source-side DRs.
To configure register-related parameters:
Ste
p
Command Remarks
1452. Enter system view. system-view N/A
1453. Enter IPv6 PIM view.
pim ipv6 N/A
1454. Configure a filtering rule for
register messages.
register-policy acl6-number
Optional.
No register filtering rule by default.
1455. Configure the device to
calculate the checksum based on
the entire register messages.
register-whole-checksum
Optional.
Based on the header of register
messages by default.
1456. Configure the register
suppression time.
register-suppression-timeout
interval
Optional.
60 seconds by default.
1457. Configure the register probe
time.
probe-interval interval
Optional.
5 seconds by default.
993BConfiguring switchover to SPT
Both the receiver-side DR and the RP can periodically check the traffic rate of passing-by IPv6 multicast
packets and thus trigger a switchover from RPT to SPT.
Perform the following configuration on routers that might become receiver-side DRs and on C-RP routers.
To configure switchover to SPT:
Ste
p
Command Remarks
1458. Enter system view. system-view N/A
1459. Enter IPv6 PIM
view.
pim ipv6 N/A
1460. Enter IPv6 PIM
view.
spt-switch-threshold infinity
[ group-policy acl6-number
[ order order-value ] ]
Optional.
By default, the device switches to the SPT
immediately after it receives the first IPv6
multicast packet from the RPT.
331B
Configuring IPv6 PIM-SSM
IPv6 PIM-SSM model needs the support of MLDv2. Be sure to enable MLDv2 on IPv6 PIM routers with
receivers attached to them.
994BIPv6 PIM-SSM configuration task list