F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

879
Ste
p
Command Remarks
1489. Enter system view. system-view N/A
1490. Enter IPv6 PIM view.
pim ipv6 N/A
1491. Set the prune delay
timer.
prune delay interval
Optional.
By default, no prune delay timer is set.
1004BConfiguring common IPv6 PIM timers
IPv6 PIM routers discover IPv6 PIM neighbors and maintain IPv6 PIM neighboring relationship with other
routers by periodically sending hello messages.
After receiving a hello message, an IPv6 PIM router waits a random period, which is smaller than the
maximum delay between hello messages, before sending a hello message. This avoids collisions that
occur when multiple IPv6 PIM routers send hello messages simultaneously.
An IPv6 PIM router periodically sends join/prune messages to its upstream for state update. A join/prune
message contains the join/prune timeout timer. The upstream router sets a join/prune timeout timer for
each pruned downstream interface.
Any router that has lost assert election will prune its downstream interface and maintain the assert state
for a period of time. When the assert state times out, the assert loser will resume IPv6 multicast
forwarding.
When a router fails to receive subsequent IPv6 multicast data from the IPv6 multicast source S, the router
does not immediately delete the corresponding (S, G) entry. Instead, it maintains the (S, G) entry for a
period of time (namely, the IPv6 multicast source lifetime) before deleting the (S, G) entry.
NOTE:
If no special networking requirements are raised, use the default settings for the timers.
1805BConfiguring common IPv6 PIM timers globally
Ste
p
Command Remarks
1492. Enter system view. system-view N/A
1493. Enter IPv6 PIM view.
pim ipv6 N/A
1494. Configure the hello
interval.
timer hello interval
Optional.
30 seconds by default.
1495. Configure the
join/prune interval.
timer join-prune interval
Optional.
60 seconds by default.
1496. Configure the
join/prune timeout timer.
holdtime join-prune interval
Optional.
210 seconds by default.
1497. Configure assert timeout
timer.
holdtime assert interval
Optional.
180 seconds by default.
1498. Configure the IPv6
multicast source lifetime.
source-lifetime interval
Optional.
210 seconds by default.