F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

890
with the Scope field value in their group addresses being 4. Serial 2/1 of Router E acts as a C-BSR and
a C-RP of the global scope zone, which serve IPv6 multicast groups with the Scope field value in their
group addresses being 14.
MLDv1 runs between Router A, Router D, Router H, and their respective receivers.
Figure 408 Network diagram
Device Interface IPv6 address Device Interface IPv6 address
Router A Eth1/1 1001::1
/
64 Router C S2/1 3002::2/64
Eth1/2 1002::1/64 S2/2 6001::1/64
Firewall GE0/1 2001::1
/
64 POS5/1 6002::1
/
64
GE0/2 1002::2/64 Router D Eth1/1 7001::1
/
64
GE0/3 2002::1/64 S2/1 3003::2/64
GE0/4 2003::1
/
64 S2/2 6001::2/64
Router B Eth1/1 3001::1
/
64 Router E S2/1 8001::1
/
64
S2/1 3002::1/64 POS5/1 6002::2/64
S2/2 3003::1
/
64 Eth1/1 2003::2/64
POS5/1 2002::2/64 Router F Eth1/1 9001::1
/
64
POS5/2 3004::1/64 S2/1 8001::2/64
Router G S2/1 4001::1
/
64 Source 1 — 2001::100/64
POS5/1 3004::2/64 Source 2 — 3001::100/64
Router H Eth1/1 5001::1/64 Source 3 — 9001::100/64
S2/1 4001::2/64
1814BConfiguration procedure
1. Assign IPv6 addresses and configure unicast routing:
Router A
Firewall
ZBR
Router B
ZBR
Router C
ZBR
Router D
Router GRouter H
Router E
Router F
Source 3
Source 1
Source 2
Receiver
Host A
S2/1
S2/2
Eth
1/
2
Eth
1/1
POS5/2 S2/1
S2/2
POS5/1
POS5/1
S2/1
S2/1
Eth1/1
S2
/1
S2/2
Eth1/1
S2/1
S2/1 POS5/1
Eth
1/1
Eth1/1 GE0/1
GE0/4
GE0/3 Eth1/1Eth1/2
GE0/2
Admin-scope 2
PIM-SM
Global-scope
Admin-scope 1
Receiver
Host B
Receiver
Host C