F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

891
a. Assign an IPv6 address and prefix length to each interface according to 3054HFigure 408. (Details
not shown.)
b. Configure OSPFv3 on the routers in the IPv6 PIM-SM domain to make sure they are
interoperable at the network layer. (Details not shown.)
2. Enable IPv6 multicast routing and IPv6 administrative scoping, MLD and IPv6 PIM-SM:
# On Router A, enable IPv6 multicast routing and IPv6 administrative scoping, enable MLD on the
host-side interface Ethernet 1/1, and enable IPv6 PIM-SM on each interface.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] pim ipv6
[RouterA-pim6] c-bsr admin-scope
[RouterA-pim6] quit
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] mld enable
[RouterA-Ethernet1/1] pim ipv6 sm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] pim ipv6 sm
[RouterA-Ethernet1/2] quit
# Enable IPv6 multicast routing and IPv6 administrative scoping, MLD and IPv6 PIM-SM on Router
B and Router H in the same way. (Details not shown.)
# On the firewall, enable IPv6 multicast routing and IPv6 administrative scoping, and enable IPv6
PIM-SM on each interface.
<Firewall> system-view
[Firewall] multicast ipv6 routing-enable
[Firewall] pim ipv6
[Firewall-pim6] c-bsr admin-scope
[Firewall-pim6] quit
[Firewall] interface gigabitethernet 0/1
[Firewall-GigabitEthernet0/1] pim ipv6 sm
[Firewall-GigabitEthernet0/1] quit
[Firewall] interface gigabitethernet 0/1
[Firewall-GigabitEthernet0/1] pim ipv6 sm
[Firewall-GigabitEthernet0/1] quit
[Firewall] interface gigabitethernet 0/2
[Firewall-GigabitEthernet0/2] pim ipv6 sm
[Firewall-GigabitEthernet0/2] quit
[Firewall] interface gigabitethernet 0/3
[Firewall-GigabitEthernet0/3] pim ipv6 sm
[Firewall-GigabitEthernet0/3] quit
# Enable IPv6 multicast routing and IPv6 administrative scoping, and enable IPv6 PIM-SM on
Router B, Router C, Router E, Router F, and Router G in the same way. (Details not shown.)
3. Configure an IPv6 admin-scope zone boundary:
# On the firewall, configure GigabitEthernet 0/3 and GigabitEthernet 0/4 as the boundary of
IPv6 admin-scope zone 1.
[Firewall] interface gigabitethernet 0/3
[Firewall-GigabitEthernet0/3] multicast ipv6 boundary scope 4