F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

902

Figure 409 Network diagram

Device Interface IPv6 address Device Interface IPv6 address

Firewall GE0/1 1001::1/64

Router C

Eth1/1 4001::1/64

GE0/2 1002::1/64 Eth1/2 1002::2/64

GE0/3 1003::1/64

POS5/0 4002::1/64

Router A Eth1/1 2001::1/64

Router D

POS5/0 3001::2/64

POS5/0 2002::1/64 POS5/1 2002::2/64

Router B Eth1/1 2001::2/64

Eth1/1 1003::2/64

POS5/0 3001::1/64

POS5/3 4002::2/64

1817BConfiguration procedure

1. Enable IPv6 forwarding and configure IPv6 addresses and IPv6 unicast routing:

a. Enable IPv6 forwarding on each router and configure the IPv6 address and prefix length for

each interface according to

3055HFigure 409. (Details not shown.)

b. Configure OSPFv3 on the routers in the IPv6 PIM-SSM domain to make sure they are

interoperable at the network layer. (Details not shown.)

2. Enable IPv6 multicast routing, MLD and IPv6 PIM-SM:

# On the firewall, enable IPv6 multicast routing globally, enable MLDv2 on GigabitEthernet 0/1,

and enable IPv6 PIM-SM on each interface.

<Firewall> system-view

[Firewall] multicast ipv6 routing-enable

[Firewall] interface gigabitethernet 0/1

[Firewall-GigabitEthernet0/1] mld enable

[Firewall-GigabitEthernet0/1] mld version 2

[Firewall-GigabitEthernet0/1] pim ipv6 sm

[Firewall-GigabitEthernet0/1] quit

GE0/2

Eth1