F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

909
1017BConfiguring the MLD version
Because MLD message types and formats vary with MLD versions, the same MLD version should be
configured for all routers on the same subnet before MLD can work properly.
1831BConfiguring an MLD version globally
Ste
p
Command Remarks
1514. Enter system view.
system-view N/A
1515. Enter MLD view.
mld N/A
1516. Configure an MLD version
globally.
version version-number MLDv1 by default.
1832BConfiguring an MLD version on an interface
Ste
p
Command Remarks
1517. Enter system view.
system-view N/A
1518. Enter interface view.
interface interface-type interface-number N/A
1519. Configure an MLD
version on the interface.
mld version version-number MLDv1 by default.
1018BConfiguring static joining
After an interface is configured as a static member of an IPv6 multicast group or an IPv6 multicast source
and group, it will act as a virtual member of the IPv6 multicast group to receive IPv6 multicast data
addressed to that IPv6 multicast group for the purpose of testing IPv6 multicast data forwarding.
When you configure static joining, follow these guidelines:
• Before you can configure an interface on an IPv6 PIM-SM device as a static member of an IPv6
multicast group or an IPv6 multicast source and group:
{ If the interface is IPv6 PIM-SM enabled, it must be an IPv6 PIM-SM DR.
{ If this interface is MLD enabled but not IPv6 PIM-SM enabled, it must be an MLD querier. For
more information about IPv6 PIM-SM and a DR, see Appendix Protocol References.
• A static member port does not respond to queries from the MLD querier. When you configure an
interface as a static member port or cancel this configuration on the interface, the interface does not
unsolicitedly send any MLD report or an MLD done message.
To configure a static member of an IPv6 multicast group or an IPv6 multicast source and group:
Ste
p
Command Remarks
1520. Enter system view.
system-view N/A
1521. Enter interface view.
interface interface-type
interface-number
N/A
1522. Configure a static
member of an IPv6 multicast
group or an IPv6 multicast
source and group.
mld static-group
ipv6-group-address [ source
ipv6-source-address ]
By default, an interface is not a
static member of any IPv6 multicast
group or IPv6 multicast source and
group.