F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

915
1025BEnabling the MLD host tracking function
With the MLD host tracking function, the router can record the information of the member hosts that are
receiving IPv6 multicast traffic, including the host IPv6 address, running duration, and timeout time. You
can monitor and manage the member hosts according to the recorded information.
1839BEnabling the MLD host tracking function globally
Ste
p
Command Remarks
1561. Enter system view.
system-view N/A
1562. Enter MLD view. mld N/A
1563. Enable the MLD host tracking function
globally.
host-tracking Disabled by default.
1840BEnabling the MLD host tracking function on an interface
Ste
p
Command Remarks
1564. Enter system view.
system-view N/A
1565. Enter interface view. interface interface-type interface-number N/A
1566. Enable the MLD host
tracking function on the
interface.
mld host-tracking Disabled by default.
340B
Configuring MLD SSM mapping
For some certain restrictions, some receiver hosts on an SSM network might run MLDv1. To provide SSM
service support for these receiver hosts, configure the MLD SSM mapping feature on the last-hop router.
1026BConfiguration prerequisites
Before you configure the MLD SSM mapping feature, complete the following tasks:
• Enable IPv6 forwarding and configure an IPv6 unicast routing protocol so that all devices in the
domain can be interoperable at the network layer.
• Configure basic MLD functions.
1027BEnabling MLD SSM mapping
Ste
p
Command Remarks
1567. Enter system view. system-view N/A
1568. Enter interface view.
interface interface-type
interface-number
N/A
1569. Enable the MLD SSM
mapping feature.
mld ssm-mapping enable Disabled by default.