F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

919
Figure 410 Network diagram
1844BConfiguration procedure
1. Enable IPv6 forwarding, assign IPv6 addresses, and configure IPv6 unicast routing:
a. Enable IPv6 forwarding on each router and assign an IPv6 address and prefix length to each
interface according to
3074HFigure 410. (Details not shown.)
b. Configure OSPFv3 on the routers to make sure they are interoperable at the network layer and
they can dynamically update their routing information. (Details not shown.)
2. Enable the IPv6 multicast routing, MLD, and IPv6 PIM-DM:
# On Firewall A, enable IPv6 multicast routing globally, enable MLD on the host-side interface
GigabitEthernet 0/1, and enable IPv6 PIM-DM on each interface.
<FirewallA> system-view
[FirewallA] multicast ipv6 routing-enable
[FirewallA] interface gigabitethernet 0/1
[FirewallA-GigabitEthernet0/1] mld enable
[FirewallA-GigabitEthernet0/1] pim ipv6 dm
[FirewallA-GigabitEthernet0/1] quit
[FirewallA] interface gigabitethernet 0/2
[FirewallA-GigabitEthernet0/2] pim ipv6 dm
[FirewallA-GigabitEthernet0/2] quit
# On Firewall B, enable IPv6 multicast routing globally, enable MLD on the host-side interface
GigabitEthernet 0/1, and enable IPv6 PIM-DM on each interface.
<FirewallB> system-view
[FirewallB] multicast ipv6 routing-enable
[FirewallB] interface gigabitethernet 0/1
[FirewallB-GigabitEthernet0/1] mld enable
[FirewallB-GigabitEthernet0/1] pim ipv6 dm
[FirewallB-GigabitEthernet0/1] quit
[FirewallB] interface gigabitethernet 0/2
Firewall A
Firewall B
Querier
IPv6 PIM network
N1
N2
Receiver
Receiver
Host A
Host B
Host C
Host D
GE0/1
3000::12/64
GE0/1
3001::10/64
GE0/2
GE0/2