F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

935
Ste
p
Command Remarks
1609. Set a cost type for routing
information.
apply cost-type [ external | internal
| type-1 | type-2 ]
Optional.
Not set by default.
Support for the apply cost-type
command depends on the
device model.
1610. Set the next hop.
• Set the next hop for IPv4 routes:
apply ip-address next-hop
ip-address
• Set the next hop for IPv6 routes:
apply ipv6 next-hop
ipv6-address
Optional.
Not set by default.
Support for the apply ipv6
next-hop command depends
on the device model.
1611. Set the IP precedence.
apply ip-precedence
ip-precedence-value
Optional.
Not set by default.
1612. Inject routing information
to a specified ISIS level.
apply isis { level-1 | level-1-2 |
level-2 }
Optional.
Not configured by default.
Support for the apply isis
command depends on the
device model.
1613. Set the local preference
for BGP routing information.
apply local-preference preference
Optional.
Not set by default.
Support for the apply
local-preference command
depends on the device model.
1614. Set the ORIGIN attribute
for BGP routes.
apply origin { egp as-number | igp |
incomplete }
Optional.
Not set by default.
Support for the apply origin
command depends on the
device model.
1615. Set the preference for the
routing protocol.
apply preference preference
Optional.
Not set by default.
1616. Set a preferred value for
BGP routes.
apply preferred-value
preferred-value
Optional.
Not set by default.
Support for the apply
preferred-value command
depends on the device model.
1617. Set a tag value for
RIP,,IS-IS, or OSPF route.
apply tag value
Optional.
Not set by default.
Support for the value argument
depends on the device model.
1047BConfiguring a continue clause
Follow these guidelines when you configure a continue clause: