F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices System Management and Maintenance Command Reference-6PW100

99
After the above configuration, log in to the FTP server by using the username ftp. The following log
information is displayed on the log host (the -DevIP=2.2.2.2 field identifies the source IP address):
<189>May 31 05:38:14 2003 Sysname %%10FTPD/5/FTPD_LOGIN(l): -DevIP=2.2.2.2; User ftp
(192.168.1.23) has logged in successfully.
info-center monitor channel
Use info-center monitor channel to configure the monitor channel. The system uses this channel to output
information to the monitor.
Use undo info-center monitor channel to restore the default monitor output channel.
Syntax
info-center monitor channel { channel-number | channel-name }
undo info-center monitor channel
Default
The system outputs information to the monitor through channel 1.
Views
System view
Default command level
2: System level
Parameters
channel-number: Specifies a channel by its number in the range of 0 to 9.
channel-name: Specifies a channel by its name, a default name or a self-defined name. For information
about configuring a channel name, see info-center channel name.
Usage guidelines
The info-center monitor channel command takes effect only after the information center enabled with the
info-center enable command.
Examples
# Output system information to the monitor through channel 0.
<Sysname> system-view
[Sysname] info-center monitor channel 0
info-center security-logfile alarm-threshold
Use info-center security-logfile alarm-threshold to set the alarm threshold for security log file usage.
Use undo info-center security-logfile alarm-threshold to restore the default.
Syntax
info-center security-logfile alarm-threshold usage
undo info-center security-logfile alarm-threshold
Default
The alarm threshold for security log file usage is 80. That is, when the usage of the security log file
reaches 80%, the system outputs a message to inform the administrator.