Manualshelf

F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices System Management and Maintenance Command Reference-6PW100

ManualsBrandsHP ManualsComputer AccessoriesHP 7100/7200 IPsec dl Module
11121314151617181920
9
tracert ipv6
Use tracert ipv6 to view the path the IPv6 packets traverse from source to destination.
Syntax
tracert ipv6 [ -f first-ttl | -m max-ttl | -p port | -q packet-number | -vpn-instance vpn-instance-name | -w
timeout ] * host
Views
Any view
Default command level
0: Visit level
Parameters
-f first-ttl: Specifies the first TTL, or, the allowed number of hops for the first packet. It ranges from 1 to 255
and defaults to 1, and must be less than the maximum TTL.
-m max-ttl: Specifies the maximum TTL, or, the maximum allowed number of hops for a packet. It ranges
from 1 to 255 and defaults to 30, and must be greater than the first TTL.
-p port: Specifies the UDP port number of the destination, which ranges from 1 to 65535 and defaults to
33434. It is unnecessary to modify this parameter.
-q packet-number: Specifies the number of probe packets sent each time, which ranges from 1 to 65535
and defaults to 3.
-vpn-instance vpn-instance-name: Specifies the VPN to which the destination belongs, where
vpn-instance-name is a case-sensitive string of 1 to 31 characters. If the destination is on the public
network, do not specify this option.
-w timeout: Specifies the timeout time of the reply packet of a probe packet, which ranges from 1 to
65535 milliseconds and defaults to 5000 milliseconds.
host: IPv6 address or host name of the destination, which is a string of 1 to 255 characters.
Usage guidelines
In the event of network failure, you can use the tracert command to determine the failed nodes.
Output from the tracert ipv6 command includes IPv6 addresses of all the Layer 3 devices the packets
traverse from source to destination. Asterisks (* * *) are displayed if the device cannot reply with an
ICMP error message (probably because the destination is unreachable or sending ICMP
timeout/destination unreachable packets is disabled).
To abort the tracert operation during the execution of the command, press Ctrl+C.
The following matrix shows the tracert ipv6 command and firewalls and UTM devices compatibility:
Hardware Command com
p
atible
F1000-A-EI/F1000-S-EI Yes
F1000-E Yes
F5000 Yes
Firewall module Yes
U200-A Yes