F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices System Management and Maintenance Command Reference-6PW100

178
snmp-agent sys-info { contact sys-contact | location sys-location | version v3 }
undo snmp-agent sys-info { contact | location | version v3 }
Default
• Contact—Null
• Location—Null
• Version—SNMPv3.
Views
System view
Default command level
3: Manage level
Parameters
contact sys-contact: Specifies the system contact, a string of 1 to 200 characters.
location sys-location: Specifies the system location, a string of 1 to 200 characters.
version: Specifies SNMP versions.
• all: Specifies SNMPv1, SNMPv2c, and SNMPv3.
• v1: Specifies SNMPv1.
• v2c: Specifies SNMPv2c.
• v3: Specifies SNMPv3.
Usage guidelines
Configure the SNMP agent with the same SNMP version as the NMS for successful communications
between them.
In FIPS mode, SNMPv3 is not supported.
Examples
# Configure the system contact as Dial System Operator at beeper # 27345.
<Sysname> system-view
[Sysname] snmp-agent sys-info contact Dial System Operator at beeper # 27345
snmp-agent target-host
Related commands
display snmp-agent sys-info
snmp-agent target-host
Use snmp-agent target-host to configure a target host for receiving traps sent by the SNMP agent.
Use undo snmp-agent target-host to remove settings for an SNMP trap target host.
Syntax
In non-FIPS mode:
snmp-agent target-host trap address udp-domain { ip-address | ipv6 ipv6-address } [ udp-port
port-number ] [ vpn-instance vpn-instance-name ] params securityname security-string [ v1 | v2c | v3
[ authentication | privacy ] ]