F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices System Management and Maintenance Command Reference-6PW100

249
ftp ipv6
Use ftp ipv6 to log in to an FTP server and enter FTP client view.
Syntax
ftp ipv6 [ server-address [ service-port ] [ vpn-instance vpn-instance-name ] [ source ipv6
source-ipv6-address ] [ -i interface-type interface-number ] ]
Views
User view
Default command level
3: Manage level
Parameters
server-address: IP address or host name of the remote FTP server.
service-port: TCP port number of the FTP server, in the range of 0 to 65535. The default value is 21.
source ipv6 source-ipv6-address: Specifies a source IPv6 address for transmitted FTP packets. This
address must be an IPv6 address that has been configured on the device.
-i interface-type interface-number: Specifies an output interface by its type and number. This parameter
can be used only when the FTP server address is a link local address and the specified output interface
has a link local address. For the configuration of link local addresses, see the chapter on IPv6 basics in
Network Management Configuration Guide.
vpn-instance vpn-instance-name: Specifies the VPN that the FTP server belongs to. The
vpn-instance-name argument is a case-sensitive string of 1 to 31 characters. If the FTP server is on the
public network, do not specify this option.
Usage guidelines
If no parameters are specified, this command enters the FTP client view without logging in to an FTP
server.
If the FTP server parameters are specified, you also need to enter the username and password for
accessing the FTP server.
NOTE:
This command is applicable only to IPv6 networks.
The following matrix shows the ftp ipv6 command and firewalls and UTM devices compatibility:
Hardware Command com
p
atible
F1000-A-EI/F1000-S-EI Yes
F1000-E Yes
F5000 Yes
Firewall module Yes
U200-A Yes
U200-S No